Compact PV Array
Site-optimized module count and tilt for seasonal energy production.
Solar Power for Wireless Repeaters
Compact, autonomous energy systems for repeaters installed on ridges, remote corridors and other hard-to-reach network locations.
EXTEND COVERAGE ANYWHERE
Power low-load sites without extending the grid
Wireless repeaters often sit beyond practical utility service and may require costly site visits. A properly sized solar and battery system supports year-round operation with minimal routine maintenance.
- Mountain and ridge sites
- Rural coverage infill
- Emergency communications
- Private radio networks
- Low-power relay stations
- Temporary network expansion
Simple, efficient DC solar power
Low-loss DC architecture minimizes conversion stages and uses modular storage to deliver the required autonomy.
MPPT Controller
Efficient charging with temperature and battery protection logic.
Battery Storage
LiFePO4 capacity sized for nights and consecutive low-sun days.
DC Distribution
Protected output for repeater, backhaul and environmental loads.
Remote Telemetry
Voltage, current, temperature and alarm monitoring from the NOC.
Rugged components for inaccessible sites
High-Efficiency PV
Compact arrays that maximize output where mounting area is constrained.
LiFePO4 Battery Pack
Long-cycle storage with low maintenance and integrated protection.
DC Solar Controller
High-efficiency MPPT charging with programmable load management.
Weatherproof Cabinet
Secure enclosure for batteries, controller and site distribution.
Pole & Ground Mounts
Flexible racking engineered for local wind, snow and terrain conditions.
Remote Monitoring
Early warning for low battery, overload, temperature and cabinet access.
Design priorities for repeater sites
Efficient DC design
Minimize conversion losses to reduce array and battery size.
Low-sun design margin
Model the worst solar month rather than relying on annual averages.
Minimal maintenance
Use long-life components and remote alarms to reduce site visits.
CUSTOMIZED PACKAGE
A preconfigured site kit for field deployment
Receive a coordinated equipment package with array layout, wiring schedule, protection plan and commissioning settings.
- Confirm repeater and auxiliary DC loads
- Assess location, solar zone and access restrictions
- Size PV, storage and enclosure configuration
- Factory-test the integrated power package
- Provide installation and remote setup support